CORRECTION SLIP 4 T0 12 OF ACCIDENT MANUAL WCR 2007 EDITION

30-11-2021

CORRECTION SLIP 4 T0 12 OF ACCIDENT MANUAL WCR 2016 EDITION Click Above or See Below

Read More
ACT (RS) ABB Loco (English) (26. PASSING NEUTRAL SECTION)
January 10, 2021

PASSING NEUTRAL SECTION ( SU )  Before approaching neutral section: 1-Ensure that MR pressure is between 8.5 to 10 kg/cm2 2-Bring TE / BE throttle to ‘0” gradually before 250M board. 3-At DJ open board, open DJ by BLDJ, LSDJ will glow, Aux. sound will stop, but U meter will show OHE supply. 4-At actual neutral section

Read More
Index-Store Department Guide – Indian Railway (Hindi)
January 10, 2021

 क्रय में विविध अधिमान्यताए मानकीकरण एवं उसकी उपयोगिता वित्तीय औचित्य के सिध्दांत भण्डार डिपो की संरचना भण्डार का

Read More
ACT (RS) ABB Loco (English) (25. VIGILANCE CONTROL DEVICE)
January 10, 2021

Automatic Vigilance Control System  VCD is meant for checking and keeping the driver alert. It is a safety device. A foot switch of VCD is provided below driver’s desk in each cab, also press button ‘BPVG’ is provided on drivers’ desk on Asst. side. Driver/Asst. driver is expected to activate VCD within every 60 seconds interval

Read More
ACT (RS) ABB Loco (English) (24. EMERGENCY STOP PUSH BUTTON)
January 10, 2021

Emergency Stop Push Button  One red colored and arrowed push button is provided on panel ‘A’ at such a place that driver as well as Asst. driver can operate it. In normal condition it remain projected out. In case of an emergency if drivers/Asst. push this button, button go inside and remain pressed and following actions initiated. 1.

Read More
ACT (RS) ABB Loco (English) (23. CONSTANT SPEED CONTROLLER )
January 10, 2021

Constant Speed Controller This system enables the train to maintain a constant speed automatically and can be activated at any speed above 5 KMPH by pressing illuminated push button ‘BPCS’.  The control electronics and GTO controls the constant speed by giving tractive or braking effort to the TM as per requirement irrespective of

Read More
ACT (RS) ABB Loco (English) (20. LOCO BRAKE TESTING)
January 10, 2021

Loco Brake Testing 1) Apply loco brakes by SA-9 2) Ensure that brake cylinders registered 3.5kg/cm2 pressure in WAG9 & 5 Kg/CM2 disk brake pressure in WAP5. 3) Release parking brakes and release A-9 4) Operate MPJ to forward. 5) Move throttle in traction and give 45 % or 150 KN tractive effort in WAG9 & 30% or 100 KN.

Read More

Latest News

General Manager’s Safety Award for 10 Staff of Central Railway